06-29-2010, 03:32 AM
Hallo,
This is Infineon Raceway for ICR2. It consist of two version of the track: one that was used in 2005-2007 (Infineon1), second - in 2008-2009 (Infineon2). Difference is in turn 7.
To install track you need to extract Infineon_p1 and Infineon_p2 in to Tracks folder. After this go to 'Infineon' and run Switch.bat. Infineon1 will be istall, run again - you will get Infineon2. I don't make separate tracks because they are the same everywhere except t7, and I don't know how to name their folders
Now about bad things...
This track has few bugs. But it will not damaged your race if you are careful.
I used google maps to create track. I've tested track all the time during creation process, but I used only racing line and didn't run out of track at some parts. I noticed some problems when I start to work on AI. It was late to change anything so we have another buggy track from me.
Problems are after turn 7 and in turn 8 which are too close to dragstrip.
Infineon1 (2005-2007) has only one bad place - it is turn 8 (look at picture). Don't ride near the right wall there.
Infineon2 (2008-2009) is bad at both afte t7 and in t8. T8 has the same situation as in Infineon1. You should not ride near the right wall. Section after t7 is very bad. After turn 7 you should try to keep your car between left edge of the track and middle of asphalt! Racing groove is already there so you will not have problem when run alone. But on the formation lap when you start on the right side keep car closer to your opponent on the left through this section!
Try to run practice section to find edge of the bad zones. If you don't like Infineon2 you still can use only Infineon1, which is better.
Good racing!
This is Infineon Raceway for ICR2. It consist of two version of the track: one that was used in 2005-2007 (Infineon1), second - in 2008-2009 (Infineon2). Difference is in turn 7.
To install track you need to extract Infineon_p1 and Infineon_p2 in to Tracks folder. After this go to 'Infineon' and run Switch.bat. Infineon1 will be istall, run again - you will get Infineon2. I don't make separate tracks because they are the same everywhere except t7, and I don't know how to name their folders
Now about bad things...
This track has few bugs. But it will not damaged your race if you are careful.
I used google maps to create track. I've tested track all the time during creation process, but I used only racing line and didn't run out of track at some parts. I noticed some problems when I start to work on AI. It was late to change anything so we have another buggy track from me.
Problems are after turn 7 and in turn 8 which are too close to dragstrip.
Infineon1 (2005-2007) has only one bad place - it is turn 8 (look at picture). Don't ride near the right wall there.
Infineon2 (2008-2009) is bad at both afte t7 and in t8. T8 has the same situation as in Infineon1. You should not ride near the right wall. Section after t7 is very bad. After turn 7 you should try to keep your car between left edge of the track and middle of asphalt! Racing groove is already there so you will not have problem when run alone. But on the formation lap when you start on the right side keep car closer to your opponent on the left through this section!
Try to run practice section to find edge of the bad zones. If you don't like Infineon2 you still can use only Infineon1, which is better.
Good racing!
